How to Setup / Control ECO electronics (Quiz)

Quiz Summary

0 of 8 Questions completed

Questions:

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading…

You must sign in or sign up to start the quiz.

You must first complete the following:

Results

Quiz complete. Results are being recorded.

Results

0 of 8 Questions answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Current
Review
Answered
Correct
Incorrect

Question 1 of 8

1. Question
How do you program the entry/exit chair memory position?
- Bring the chair to desired position and press and hold down the entry/exit memory button until an audible signal is heard. DE20 chairs are not programmable.
- Bring the chair to desired position, switch the unit off, press and hold down the entry/exit memory button, switch the unit back on, keep holding the button for 10 seconds and then release. Audible signal confirms successful programming. DE20 chairs are not programmable.
- It's not possible at all.
Correct

Incorrect
Question 2 of 8

2. Question
How do you switch micro-motor or turbine cooling from spray to water and vice versa?
- By holding the cooling mode button for 2 seconds. LED changes between solid on and flashing.
- It's not possible.
Correct

Incorrect
Question 3 of 8

3. Question
How do you program the spitoon position?
- Press and hold down the spitoon-position-button for 5 seconds. DE20 chairs are not programmable.
- Bring the chair to desired position and then press memory-button, entry/exit-position-button and chair-movement-down-button in quick sequence. DE20 chairs are not programmable.
Correct

Incorrect
Question 4 of 8

4. Question
Can you have DENSIM DX PRO micro-motors on Classic Line units?
- No. There are no buttons to control endodontic functions of DX PRO micro-motors.
- Yes. Why not?
Correct

Incorrect
Question 5 of 8

5. Question
Can you have full chair control from the assistant side arm?
- No.
- Yes, assistant side can have full chair control.
Correct

Incorrect
Question 6 of 8

6. Question
How do you program cup filling time?
- By manually adjusting the water throughput limiter screw.
- By holding the cup filling button for the desired time. Allowed range is between 4 and 35 seconds.
- It;s not possible on ECO electronics. Cup filling time comes programmed from factory.
Correct

Incorrect
Question 7 of 8

7. Question
Can you have DENSIM micro-motors with the BLUE LIGHT feature on Classic Line units?
- No, this is possible on high end units.
- Yes, BLUE light feature of DENSIM micro-motors is an available option on every DIPLOMAT dental unit.
Correct

Incorrect
Question 8 of 8

8. Question
Can you flush the bowl using a foot controller?
- Only when the unit is switched off.
- Yes, when all instruments are in dentist panel, activating the foot controller lever/pedal triggers the bowl flush function.
- No.
Correct

Incorrect

How to Setup / Control ECO electronics (Quiz)

Quiz Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question